Pjūklas stumdomam siaurapjūkliui | apskritimams pjauti | OSB, gipso kartonas, medis, laminatas | HCS 120 mm 12T (YT-33972) (Kodas: YT-33972)
Prekių nuotraukos skirtos tik iliustraciniams tikslams, originalių produktų spalvos, užrašai, parametrai, matmenys, dydžiai, funkcijos, ir/ar bet kurios kitos savybės dėl savo vizualinių ypatybių gali atrodyti kitaip negu realybėje, todėl prašome vadovautis prekių savybėmis, kurios nurodytos prekių aprašymuose. Kilus klausimams, visada laukiame Jūsų skambučio telefonu +370 650 61061 arba el. paštu info@drdtools.lt.
Gamintojas: Yato
Mark
Yato
Symbol
YT-33972
Series
GRD
Material
HCS
Application
wet wood and branches (Ø5-70 mm)|for plunge and curve cuts
For
YT-82281|YT-82814|YT-82815|YT-82904
Length
120mm
Thickness
1.2mm
Tool holder type
standard
Teeth per inch
12TPI
Mark
Yato
Symbol
YT-33972
Series
GRD
Material
HCS
Application
wet wood and branches (Ø5-70 mm)|for plunge and curve cuts
For
YT-82281|YT-82814|YT-82815|YT-82904
Length
120mm
Thickness
1.2mm
Tool holder type
standard
Teeth per inch
12TPI
Blade for use with a reciprocating saw to cut circles in OSB boards, plasterboards, wood and laminates, e.g. holes for ventilation or sewage. The fork tip of the blade, working at full speed, after applying it at an angle of about 30 °, allows the blade to sink into the material. The small cross-section makes it possible to make round and bevel cuts. It also allows you to change the cutting direction while working with the saw blade.
Yato
Symbol
YT-33972
Series
GRD
Material
HCS
Application
wet wood and branches (Ø5-70 mm)|for plunge and curve cuts
For
YT-82281|YT-82814|YT-82815|YT-82904
Length
120mm
Thickness
1.2mm
Tool holder type
standard
Teeth per inch
12TPI
Mark
Yato
Symbol
YT-33972
Series
GRD
Material
HCS
Application
wet wood and branches (Ø5-70 mm)|for plunge and curve cuts
For
YT-82281|YT-82814|YT-82815|YT-82904
Length
120mm
Thickness
1.2mm
Tool holder type
standard
Teeth per inch
12TPI
Blade for use with a reciprocating saw to cut circles in OSB boards, plasterboards, wood and laminates, e.g. holes for ventilation or sewage. The fork tip of the blade, working at full speed, after applying it at an angle of about 30 °, allows the blade to sink into the material. The small cross-section makes it possible to make round and bevel cuts. It also allows you to change the cutting direction while working with the saw blade.