Staklės / giljotina grindų laminatui | 340 mm | 370 x 600 mm (YT-37311) (Kodas: YT-37311)
Prekių nuotraukos skirtos tik iliustraciniams tikslams, originalių produktų spalvos, užrašai, parametrai, matmenys, dydžiai, funkcijos, ir/ar bet kurios kitos savybės dėl savo vizualinių ypatybių gali atrodyti kitaip negu realybėje, todėl prašome vadovautis prekių savybėmis, kurios nurodytos prekių aprašymuose. Kilus klausimams, visada laukiame Jūsų skambučio telefonu +370 650 61061 arba el. paštu info@drdtools.lt.
Gamintojas: Yato
Product description
Guillotine for cutting floor panels, cutting width 340 mm, max. the thickness of the material to be cut is 16 mm. The guillotine knife is embedded in aluminum profiles mounted on vertical, steel pedestals. The pressure arm is about 600 mm long, the worktop made of a hard, wear-resistant material is 370 mm x 600 mm. Note the cutter knife is extremely sharp and you should be careful when working with it.
Purpose / application
Guillotine for cutting floor panels and other similar finishing materials up to approx. 16 mm thick.
Usage method
Place the material to be processed on the device table, between the pedestals holding the knife. then, pressing the levers with feeling, lower the blade onto the material and, pressing it, cut off the desired fragment. Due to the extreme sharpness of the knife, special attention should be paid during work.
Guillotine for cutting floor panels, cutting width 340 mm, max. the thickness of the material to be cut is 16 mm. The guillotine knife is embedded in aluminum profiles mounted on vertical, steel pedestals. The pressure arm is about 600 mm long, the worktop made of a hard, wear-resistant material is 370 mm x 600 mm. Note the cutter knife is extremely sharp and you should be careful when working with it.
Purpose / application
Guillotine for cutting floor panels and other similar finishing materials up to approx. 16 mm thick.
Usage method
Place the material to be processed on the device table, between the pedestals holding the knife. then, pressing the levers with feeling, lower the blade onto the material and, pressing it, cut off the desired fragment. Due to the extreme sharpness of the knife, special attention should be paid during work.